git 2.0的push.default的設定

官方訊息如下:

warning: push.default is unset; its implicit value is changing in
Git 2.0 from ‘matching’ to ‘simple’. To squelch this message
and maintain the current behavior after the default changes, use:

To squelch this message and adopt the new behavior now, use:

When push.default is set to ‘matching’, git will push local branches
to the remote branches that already exist with the same name.

In Git 2.0, Git will default to the more conservative ‘simple’
behavior, which only pushes the current branch to the corresponding
remote branch that ‘git pull’ uses to update the current branch.

See ‘git help config’ and search for ‘push.default’ for further information.
(the ‘simple’ mode was introduced in Git 1.7.11. Use the similar mode
‘current’ instead of ‘simple’ if you sometimes use older versions of Git)

換句話說,在Git 2.0,若將push.default設為matching,則在push時將所有local branch的變動,推上遠端branch,若設為simple,則只會推當前的branch的變動,至遠端branch。

發表迴響